Bottom rupture is one of the most expensive defects in PET bottle production.

When the bottle base cracks during blowing or filling, factories face:

LINE STOPPAGE

PRODUCT LOSS

HIGHER SCRAP RATE

FILLING INSTABILITY

Many manufacturers blame resin quality.

But in most cases:

THE REAL PROBLEM IS STRETCHING INSTABILITY.


WHY BOTTOM RUPTURE HAPPENS

Traditional PET blow molding machines use pneumatic cylinders to drive the stretch rod.

The problem?

AIR PRESSURE IS NEVER COMPLETELY STABLE.

Pressure changes caused by:

  • Ambient temperature
  • Valve wear
  • Compressor fluctuation
  • Air recovery instability

can affect stretch rod movement.

When stretching speed becomes inconsistent:

  • PET material distribution shifts
  • The gate area becomes off-center
  • The bottle base becomes too thin

Result:

STRESS CONCENTRATION AT THE BASE

WEAKER MATERIAL ORIENTATION

HIGHER RISK OF BOTTOM CRACKING

Especially during:

40 BAR HIGH-PRESSURE BLOWING

LIGHTWEIGHT BOTTLE PRODUCTION

HIGH-SPEED MULTI-CAVITY OPERATION


THE LIMITATION OF PNEUMATIC STRETCHING

Pneumatic systems cannot fully guarantee:

IDENTICAL STRETCHING SPEED

PERFECT CENTERLINE MOVEMENT

STABLE MATERIAL ORIENTATION

Even tiny movement variation between cavities can create:

  • Uneven wall thickness distribution
  • Base instability
  • Gate eccentricity
  • Crystallization imbalance

At high speed, these small differences become amplified.


THE BANGEMACHINE SERVO STRETCHING SOLUTION

BANGEMACHINE replaces pneumatic cylinders with:

FULL-SERVO STRETCH CONTROL

This creates far more stable and repeatable stretching behavior.


MICROMETER-LEVEL VELOCITY CONTROL

The stretch rod is driven by a high-torque synchronous servo motor.

Its movement profile is fully programmable.

Meaning:

PERFECTLY LINEAR STRETCHING SPEED

STABLE MATERIAL DISTRIBUTION

HIGHER BASE STRUCTURAL STRENGTH

Regardless of:

  • Temperature changes
  • Air pressure fluctuation
  • Continuous production load

REAL-TIME PLC FEEDBACK CONTROL

The servo drive communicates continuously with the PLC system.

If resistance changes inside the PET preform:

TORQUE IS ADJUSTED IN REAL TIME

This ensures:

STABLE STRETCH SYNCHRONIZATION

IDENTICAL CAVITY PERFORMANCE

LOWER PROCESS DRIFT


WHY THIS MATTERS FOR LIGHTWEIGHT BOTTLES

Lightweight bottles have thinner material distribution.

Meaning:

THE BASE AREA BECOMES MUCH MORE SENSITIVE TO STRETCHING ERROR.

Servo stretching helps maintain:

UNIFORM GATE THICKNESS

STABLE BASE ORIENTATION

LOWER STRESS CONCENTRATION

BETTER BURST RESISTANCE

Result:

SCRAP RATE BELOW 0.2%

MORE STABLE FILLING PERFORMANCE

HIGHER HIGH-SPEED PRODUCTION RELIABILITY