5 precautions for PET Bottle Blowing Machine maintenance

5 precautions for PET Bottle Blowing Machine maintenance

5 precautions for PET Bottle Blowing Machine maintenance

How can BORG PET Bottle Blowing Machine maintenance save money and keep the machine running perfectly!

1.bottle is always pinched

Whether the position of the manipulator is misplaced.

2.Two manipulators collide

In this case, the manipulator needs to be manually reset again, which is caused by dislocation

3.The bottle cannot be taken out of the mold after blowing.

First, the mold should be opened, and the mold should be opened and closed manually. If it is normal, run it in the dry running state, if it is normal. Please check your exhaust time setting. If the exhaust setting is normal and the failure occurs every time you blow the bottle, then it can be judged that it is the problem of the exhaust valve. Please open the exhaust valve to check the condition of its spring and seal (this There is also a phenomenon that the exhaust sound is relatively loud or there is a sound of unclean exhaust). If you encounter a situation where the mold cannot be opened by chance due to the normal production of many molds, please check whether the clamping pin has a segmented screw in it. In addition, please check whether the clamping force is too large. Standard readjustment.

PET Bottle Blowing Machine.jpg

4. Feeding the old card feeding tray: This situation is a headache.

From experience, if the length of the preform (preform) is longer and the weight is larger, then this phenomenon is relatively rare.

5 The feeding position of the blow molding machine does not feed: there are several situations that need to be checked:

Whether the hopper has run out of material, if so: need to add material quickly    No: please check whether the control contactor of the hoist is powered on. If it is powered on, quickly check whether the motor is powered on and loaded, because in this case, it is likely that the preform (preform) is stuck and lifted. The easiest way at this time is to manually help lift. If the control contactor of the inspection elevator is not energized, please check whether the preform detection electric eye and the reflector are not in the same line.

Professional blow molding machine manufacturer

TAIZHOU BORG BLOWING MACHINE SAMRT EQUIPENT CO,LTD.

  •